Brake pad wear sensors are a convenient part of the braking system, notifying the driver of when the material on the brake pads are getting low and need to be serviced. Unfortunately it is common in custom or upgraded braking systems that the pad wear sensor is non-existent or does not mate properly with the connector on your vehicle, leaving you with a brake pad wear warning every time you start your vehicle.
Our engineers developed a direct-fit Brake Pad Wear Sensor Bypass to alleviate this issue. This sensor bypass will trick the vehicle's electronics into thinking that the brake pads have adequate pad material to keep the dashboard warning from appearing. No more unnecessary warnings when installing a big brake kit or your own custom setup. This bypass is a plug-and-play component that requires no modifications so you can revert back to your OEM setup if necessary.
Some vehicles may be equipped with two front brake pad wear sensors, or a front and rear sensor, please be sure to double check the required quantity for your vehicle before placing an order.
*During installation, make sure to clean the mated female connector on your vehicle of any dirt or debris to ensure that the Brake Pad Wear Sensor Bypass is engaged securely.
